MaxPower Corp XVT Series - Manual (Page 3)

XVT USER'S MANUAL UNINTERRUPTIBLE POWER SUPPLY (UPS)
Xtreme Power Conversion® Corporation (Rev 8/29/13) Page 3
SAFETY INSTRUCTIONS
ATTENTION:
To safely interact with and enjoy all the features and benefits of these Xtreme Power
Conversion Uninterruptible Power Supplies (UPS), please read and follow all installation and operation
instructions completely. These UPS are designed to provide power protection for connected electronic
equipment.
Please read this manual before installing the XVT-Series UPS models XVT-600, XVT-800, XVT-1200, and
XVT-1500 as it provides important information that should be followed during installation and
maintenance of the UPS and batteries, allowing you to correctly set up your system for the maximum
safety and performance. Included is information on customer support and factory service, if it is
required. If you experience a problem with the UPS, please refer to the Troubleshooting section in this
manual to correct the problem. If the problem is not corrected, please collect information so that the
Technical Support personnel can more effectively assist you.
CAUTION:
Any changes or modifications not expressly approved by the manufacturer of this device
could void the user’s authority to operate the equipment.
FCC Notice:
This equipment has been tested and found to comply with the limits for a Class B
Digital Device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. There is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experienced technician for help. Any special accessories needed
for compliance must be specified in the instruction.
CAUTION:
A shielded-type power cord is required in order to meet FCC emission limits and to
prevent interference to the nearby radio or TV reception. It is essential that only the supplied power
cord be used. Use only shielded cables to connect I/O devices to this equipment.
CAUTION:
Any changes or modifications not expressly approved by the manufacturer of this device
could void the user’s authority to operate the equipment.