MaxPower Corp XVT Series - Manual (Page 13)

XVT USER'S MANUAL UNINTERRUPTIBLE POWER SUPPLY (UPS)
Xtreme Power Conversion® Corporation (Rev 8/29/13) Page 13
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Full-time surge protection
outlets stop providing power
to equipment
Circuit breaker has tripped due to
an overload
Turn the UPS off & unplug at least
one piece of equipment. Wait 10
sec, replace the fuse with a fuse
of like size & rating, & turn the
UPS on
The UPS does not supply
expected runtime
Battery not fully charged
Recharge the battery for at least 4
hours
The battery is defective
Contact Xtreme Power
Conversion about replacement of
batteries
The UPS will not turn on
The on/off switch is designed to
prevent damage by rapidly
turning it off and on
Turn the UPS off. Wait 10 sec &
then turn the UPS on
The UPS is not plugged into an AC
wall outlet
Connect the UPS to an 110/120V
60Hz AC wall outlet
The battery is defective
Contact Xtreme Power
Conversion about replacement of
batteries
Mechanical problem
Contact Xtreme Power
Conversion
The UPS shuts down when
there is loss of AC power
The UPS is not providing battery
power
Shutdown your load & turn the
UPS off. Wait 10 sec & turn the
UPS back on. This should reset the
UPS