Little Colorado Treasure Chest 53 - Manual (Page 2)

Treasure Chest Assembly Instructions- Continued
Revised 10/10
by
E. Layton
• Now that you have the two sides
fastened to the back; slide the
bottom panel in the bottom grooves
(The side with the Little Colorado
logo is the top side).
• Insert Cam Posts in holes on edge
of Side . This maybe a tight fit. Some
minor adjusting and fitting may be
needed.
• Insert 3 Cam Locks into the Cam Lock
holes on the side component . The
arrow head on the face of the Cam
needs to be pointing toward the head
of the Cam Post.
• Turn the Cam 1/2 turn Clockwise
until cam stops.
• Now, repeat steps 2 and 3 to
assemble the other side.
• Use a #2 Phillips head screwdriver to screw
in 3 Cam Posts to each side of Back .
• Each cam post must be fully seated and
perpendicular.
• Repeat steps 1, 2 and 3 to attach
Front panel to body
1 2 3
4 5 6
Page 2 of 3
Partial view of Side
• Using the existing holes, attach bottom of
Lid Support to inside of Back with 2 #8 x 5/8”
screws
• Place Lid on top of the box and line
up existing holes located on outside
of the back panel to holes in hinge.
Attach hinge to back of box using 14
#5 x 5/8” screws.
• Be careful not to over tighten screws.
Bottom
Quality Wooden Children’s Furniture and Accessories
Made in America • Established 1987
www . littlecolorado . com
Arrow Head
Bottom Panel
Panel Groove
Cam Post Holes
Cam Lock Holes
Body
Lid
Back
Top
Lid Support
Back Panel
Area of Detail