Little Colorado Vanity and Bench 47 - Manual

WARNING: ADULT ASSEMBLY REQUIRED
WARNING: Assembly kit contains parts with sharp edges.
WARNING: Assembly kit contains parts with sharp points.
WARNING: Package contains plastic bags that present suffocation risks for children.
WARNING: Assembly kit contains small parts that present choking hazards for children.
Quality Wooden Children’s Furniture and Accessories
Made in America • Established 1987
www . littlecolorado . com
®
Inc.
All of us at Little Colorado, Inc hope that you and your little ones enjoy this Vanity and Bench for many years.
Please call us if you have any questions.
Manufactured in America by:
Little Colorado, Inc. 4450 Lipan Street Denver, Colorado 80211
Phone 303-964-3212 Fax 303-964-3213 [email protected]
Revised 12/10
by
E. Layton
Page 1 of 1
Contents:
1- Vanity Table Top
4- Vanity Legs
1- Vanity Back
2- Vanity Supports
1- Mirror
1- Mirror Cover
1- Bench Seat
4- Bench Legs
8- Wing Nuts
8- Flat Washers
11- 5/8" Wood Screws
4- 1-5/8" Wood Screws
2- 1-1/4" Wood Screws
Assembly Instructions for Vanity and Bench Item #47
Required Tools:
Phillips Screwdriver
Please inspect all parts for damage during shipping and for any missing items. If you suspect that there may be
damage or a shortage, call us and we will send replacement parts if needed.
Remove the protective coating from the front of the mirror and place it inside the vanity back . Now lay them both front
side down on a surface that won't scratch the mirror. Position the mirror cover over the vanity back so that the holes line
up correctly. Install eight of the 5/8" screws to secure the mirror cover.
Position the two supports in front of the vanity back so that the holes line up and that the bottoms are exactly even. They
are interchangeable right or left. Now carefully install the four 1-5/8" wood screws.
Insert the bolt sticking out of the vanity leg through the hole in any corner of the vanity table top. From the inside of the
table, slide a flat washer over the bolt and screw on a wingnut as shown above. Hand tighten only. Using the same
procedure, put the other three long legs on the vanity top and the four shorter legs on the bench.
Lay the vanity table top on its back side and position the vanity back so that each pilot hole underneath the support lines
up with the corresponding hole in the vanity table top. Start a screw through the underside of the vanity table into the
support but do not tighten completely. Be certain the screw goes only into the pre-drilled hole. Now carefully position the
other support and loosely intall its screw.
Carefully move the vanity table and partially attached back into an upright position. If necessary, adjust the back so that it
is centered with the vanity table top and tighten all loose screws.
Install and tighten the remaining three 5/8" screws through the rear of the mirror cover and into the rear of the vanity table
top. There are no predrilled holes for these three screws.
1.
2.
3.
4.
5.
6.
Vanity Assembly
Leg/Table Assembly