Little Colorado Child's Adirondack Chair 140 - Manual

If this Chair is unfi nished, it must be totally protected by an outdoor/exterior rated stain or house paint
BEFORE being used outside. Exposure to any weather or even sun can cause rapid deterioration, cracking,
warping, splitting and discoloration of unfi nished wood. The Natural (clear) fi nish is for inside use only.
If this Chair is painted a solid color, the fi nish is designed to provide long lasting protection when ex-
posed to the harshness of weather. But no matter how durable, painted wooden furniture should not be left
outdoors continually. It is best to store it inside when not in use. Even in mild conditions, painted wood fur-
niture left outdoors will eventually fade and show the effects of exposure to weather. To clean your painted
furniture, use a mild detergent such as a dishwashing liquid and a soft cloth. Never use any type of abrasive
cleanser.
You will need a standard phillips screwdriver, a fl at head
screwdriver and a pair of pliers to complete assembly.
1. Please inspect the parts for damage during shipping
and for any missing items. If you suspect that there may
be damage or a shortage, call us and we will send replace-
ment parts if needed. At this time, visualize how the com-
ponents fi t together per the above drawing and make sure
that you have everything indentifed.
2. Slide the back assembly into the slots behind the seat so that it looks like the drawing. Hold the arm/
leg set and the seat assembly into position so that the holes line up and install two bolts. Start a washer
and a cap nut on each bolt and tighten hand tight only. Now attach the other arm/leg the same way.
3. Align the holes in the backs of the arms with the brace on the rear of the back assembly. Put the
bolts in the holes, add a washer and a cap nut and hand tighten.
4. Make sure the right and left sides lower brace of back assembly are fully seated in the slots and start
the two wood screws. Screw in the wood screws until tight and the heads are slightly below the surface
of the wood.
5. Place the Chair on a hard level surface with all four legs in contact with the fl oor. Using a fl at
screwdriver and a pair of pliers, tighten all cap nuts securely until the bolt heads begin to be pulled
slightly into the wood.
WARNING: ADULT ASSEMBLY REQUIRED
WARNING: Assembly kit contains parts with sharp edges.
WARNING: Assembly kit contains parts with sharp points.
WARNING: Package contains plastic bags that present suffocation risks for children.
WARNING: Assembly kit contains small parts that present choking hazards for children.
Quality Wooden Children’s Furniture and Accessories
Made in America • Established 1987
www . littlecolorado . com
®
Inc.
Revised 07/10
N. Tommer
Assembly Instructions for Child's Adirondack Chair Item #140
Contents:
2- Arm/Leg Sets (A)
1- Seat Assembly (B)
1- Back Assembly (C)
Parts
Page 1 of 1
Hardware
6- 1 3/4" Bolts
6- Cap Nuts
6- Washers
2- 1 5/8" Wood Screws
Use, Care and Cleaning:
All of us at Little Colorado, Inc. hope that you and your little ones enjoy this
Child's Adirondack Chair for many years. Please call us if you need any help in assembly.
Little Colorado, Inc. 4450 Lipan Street Denver, Colorado 80211
Phone 303-964-3212 Fax 303-964-3213 www.littlecolorado.com
A
C
B