beautypg.com

Little Colorado Play Stand Canopy (Arch) 14 User Manual

Little Colorado Products for children

background image

9/09

®

Inc.

Assembly Instructions For Play Stand Canopy (Arch) - Item #14

Note- This product must be used with and attached only to two Little Colorado Play Stands -Item #12

4- Wooden arches (2 right sides and 2 left sides)

2- Arch connector blocks

4- 35" dowels

8- 1 1/8" Black Wood screws

8- 1 5/8" Silver washer head wood screws

4- 1 1/4" Silver machine bolts

4- Silver washers

4- Silver Acorn nuts

You will need a medium size phillips

screwdriver and a pair of pliers to complete

assembly. An assistant will be helpful.

Contents:

Children's Furniture Made In America

Established 1987

www.littlecolorado.com

WARNING: Adult Assembly Required

WARNING: Assembly Kit Contains Parts With Sharp Points, Sharp Edges,

and Small Parts That Can Present Choking Hazards to Children.

WARNING: Components Are Packed In Plastic Bags That Are A Suffocation Hazard.

Page 1 of 2 pages

1. The Play Stand Canopy must be completely assembled first and then attached to the two Play Stands. Locate all the

wooden parts and lay them out on the floor in their approximate positions.

2. Select one canopy arch, place a dowel in one of the inset holes and install one of the silver 1 5/8" washer head screws

until it is tight. Now attach the other three dowels to complete one side.

3. Slide the arch connector over the two dowels on the smaller ends, line up and insert the two machine bolts. Add a washer

and acorn nut to each bolt and tighten with pliers or a 7/16" wrench. Now repeat steps 2 and 3 for the other side.

4. If your two Play Stands are already assembled, you will need to remove the dowel at the top. If not, then complete the

Play Stand assembly except for the dowels. Carefully place the canopy assembly in place so that the arches are inside

the Play Stand sides and the 3/4" holes for the dowel are alinged. Follow the Play Sand instructions to attach the dowel by

inserting it through the Play Stand sides into the arches and then screwing it in place. Finish attaching it to both Play Stands.

5. Adjust both Play Stands so that they are sitting squarely on the floor. When exactly in position, install two black 1 1/8"

wood screws through the predrilled holes in each arch and into the inside of the Play Stand sides.

Do NoT ALLoW CHILDREN To CLImB oN, PULL oN oR HANG FRom DoWELS

THE CANoPy IS NoT To BE USED AS A JUNGLE Gym

mINImUm AGE GRADE IS 2 yEARS