Little Colorado Log Cabin Play House 180 - Manual (Page 2)

5. Stand up the rear wall and a side wall and hook them
together. Two people will make this job easier. When
the walls are 90 degrees square and all four hooks are
perfectly in position the hooks will slide down and the
bottoms will be even with the fl oor. Now hook together
the remaining walls.
All of us at Little Colorado, Inc. hope that you and your little ones enjoy this Log Cabin Play House
for many years. Please call us if you need any help in assembly. Manufactured by:
Little Colorado, Inc. 4450 Lipan Street Denver, Colorado 80211
Phone 303-964-3212 Fax 303-964-3213 www.littlecolorado.com
Inside Front Wall Inside Back Wall Inside Side Wall (2)
Page 2 of 2
Wall Inside Side Wall
Back Wall to Side Wall Connection
Puppet Show
and Store
Shelf
4. First you need to assemble each of the four wall sections by attaching them together with the wooden
connector plates and 3/4” long screws. Place the panels in position per the attached illustrations. Locate
the appropriate connector plates and place them in position so that all holes line up. The side of the
connector plate with the metal T-Nut goes inside the house. Now turn the pieces upside down, reposition
the panels and the connector plates. Install the 3/4” screws in the pre-drilled holes from the outside until
snug.
6. The shelf for the puppet theatre/store comes fully assembled. After Play House is assembled, attach
shelf to large window in Back Wall by sliding the slot on the bottom of the shelf over the Bottom Panel of
the Back Wall.
7. The three sets of curtains that are the same size fi t the smaller windows. The larger set of curtains fi ts
the puppet theatre window in the Back Wall. Install the curtains to the inside of the windows using the
strips of Hook and Loop. While holding the curtains centered in the window press the Loop strip at the
top of the curtains fl atly and fi rmly against the Hook strip that is stapled along the inside top edge of the
windows. The felt door is similarly attached. The curtains and door can be gathered along the Hook and
Loop to hold them partially open if desired.
8. To attach the fabric roof, lay the fabric fl at on the fl oor and insert the 3 Dowel Rods, one at a time, into
any of the three fabric tubes on the inside of the Felt Roof. Push the Dowel Rods all the way through the
Roof until they protrude about 2 inches on either side. Set the roof inside the Play House, with the Dowel
Rod side down, and push the ends of the Dowel Rods through the circular openings in the Back Roof
Panel. Do the same at the Front. The Dowel Rods are notched and will drop into position in the front
and rear walls when properly located. Attach Hook and Loop fasteners to the tops of the outside walls to
secure roof.
9. Now that the house is completely assembled, please inspect each and every wood surface area for
rough or sharp edges that could cause splinters. The sand paper is provided to smooth any place that
needs it. Please note that this Play House is manufactured for indoor use only.
Revised 07/10 N. Tommer