beautypg.com

Mallory Ignition Mallory COMP PUMP SERIES 160FI ELECTRIC FUEL PUMP 5160FI User Manual

Page 2

background image

FIGURE 1

2

www.malloryracing.com

MALLORY IGNITION

WIRING PROCEDURE

Wiring a pump to an oil pressure switch will provide power only when the ignition switch is on and the engine is running.
This will prevent the pump from running if your engine stalls. Use 12 gauge wire or larger and be sure to disconnect the battery
ground cable before wiring the pump. Refer to Figure 3 when connecting the pump to an oil pressure switch.

FIGURE 2

FIGURE 3

12V

The pump may also be wired directly to the ignition “ON” terminal and grounded to the frame or battery.
Refer to Figure 4 when connecting the pump to the ignition switch “ON” terminal.