Mallory Ignition Mallory MAGNETIC BREAKERLESS DISTRIBUTOR User Manual

Page 3

www.malloryracing.com

MALLORY IGNITION

FIGURE 1

WIRING DIAGRAM USING OEM PRIMARY (LOOM) RESISTANCE WIRE

NOTE: The purpose of resistance wire between the ignition
switch (12V) and the ignition coil positive terminal is to restrict
current flow through the ignition coil. Failure to use resistance
wire will eventually destroy the Ignition Module.
EXCEPTION: If your vehicle is equipped with a HYFIRE

Electronic

Ignition Control or similar aftermarket ignition control, use the
wiring procedures stated in the instructions included with the
ignition control.

To prevent false triggering and possi-
ble premature ignition failure, you
must use suppression type (carbon
core, spiral core, or radio suppression
core) spark plug wire.
Do not use solid core (copper core or
stainless steel core) spark plug wire
with any electronic ignition system.

ALL OTHER WIRES ORIGINALLY CONNECTED TO THE COIL (+) TERMINAL

LOOM RESISTANCE WIRE

12V/IGNITION

SWITCH

IGNITION MODULE

FEMALE CONNECTOR

ENGINE

GROUND

BROWN

GREEN

RED

DISTRIBUTOR WIRE HARNESS PART NO. 29349

FIGURE 2

WIRING DIAGRAM USING IGNITION BALLAST RESISTOR

NOTE: The purpose of an ignition ballast resistor between the
ignition switch (12V) and the ignition coil positive terminal is to
restrict current flow through the ignition coil. Failure to use an
ignition ballast resistor will eventually destroy the Ignition
Module.
EXCEPTION: If your vehicle is equipped with a HYFIRE