Mallory Ignition Mr_Gasket Starter Motor Heat Shield 3678 User Manual
Mallory Ignition For the car
www.mr-gasket.com
Starter Motor Heat Shield #3678
Installation Instructions
Heat Shield installation may be completed without removing the starter from vehicle if there is adequate clearance
inside engine compartment.
1. Disconnect “Negative” battery cable before beginning installation.
2. Loosen both outside/inside solenoid bolt (do not remove).
3. Loosen upper front starter cover bolt and install heat shield.
4. Remove inside and outside solenoid bolts. Rotate heat shield into position and re-stall bolts.
5. Tighten all bolts mounting securely.
6. Reconnect “Negative” battery cable.
CAUTION: Be sure starter wires do not rub against Heat Shield, Engine Block or Cylinder Head.
FORM 97140000
02/13
Printed in USA
MR. GASket IS A tRADeMARk OF PReStOLIte PeRFORMANCe
10601 MeMPHIS AVe. #12, CLeVeLAND, OH 44144
PHONE 216.688.8300 • FAX 216.688.8306
family of brands
- Mallory ELECTRIC FUEL PUMP TROUBLESHOOTING GUIDE (2 pages)
- Mallory MAX-FIRE AND E-FIRE ELECTRONIC DISTRIBUTORS 2248214_2248204_2255104_2255404_2256704 (8 pages)
- Mallory COMP 9000 90 SERIES POINT TYPE DISTRIBUTOR (3 pages)
- Mr_Gasket ELECTRIC (MICRO) DIESEL FUEL PUMP 12D (4 pages)
- Mallory ENGINE MODIFICATIONS FOR O-RING DISTRIBUTORS (1 page)
- ACCEL AFTERBURNER SWITCHABLE COIL 140025 (4 pages)
- ACCEL DUAL TOWER COILS 140403/140403S/140404/140404S (2 pages)
- ACCEL COIL KIT 140405 (2 pages)
- ACCEL COIL KIT 140408, 140408BK, 140408CH (1 page)
- Lakewood safety bellhousing 15060 (5 pages)
- Lakewood Safety Bellhousing 15100/15120 (4 pages)
- ACCEL Battery Eliminator 151308 (1 page)
- Lakewood Safety bellhousing 15210_15220 (2 pages)
- Lakewood safety bellhousing starter 15320_15330 (2 pages)
- LAKEWOOD DRIVE SHAFT SAFETY LOOP 18005 (2 pages)
- LAKEWOOD FRONT DRIVE SHAFT SAFETY LOOP 18023 (1 page)
- LAKEWOOD REAR DRIVE SHAFT SAFETY LOOP 18024 (1 page)
- LAKEWOOD REAR ANTI-ROLL BAR CENTER LINKS 19101 (1 page)
- ACCEL Exhaust Wrap 2002bk_2002ta (2 pages)
- ACCEL POINTS ELIMINATOR IGNITION MODULE PN 2005 (2 pages)
- ACCEL POINTS ELIMINATOR CONVERSION 2010 (3 pages)
- Lakewood subframe connector 30201_20102 (1 page)
- LAKEWOOD REAR LOWER CONTROL ARMS 20105 (2 pages)
- ACCEL VOLTAGE REGULATOR 201104 (1 page)
- ACCEL VOLTAGE REGULATOR 201107_201107C (1 page)
- Lakewood TOE LINKS 20141_20142 (1 page)
- Lakewood REAR TRAILING ARM 20143 (1 page)
- Lakewood REAR UPPER CONTROL ARMS 20144_20149_20154 (2 pages)
- Lakewood REAR UPPER CONTROL ARMS 20152 (2 pages)
- Lakewood COIL SPRING TRACTION BAR 20188 (2 pages)
- Lakewood TRACTION BARS 20189 (2 pages)
- ACCEL POINTS ELIMINATOR CONVERSION 2020 (3 pages)
- ACCEL POINTS ELIMINATOR CONVERSION 2030 (3 pages)
- Lakewood Bolt-on Ladder Bars 20460 (1 page)
- Lakewood Competition Bolt-on Ladder Bars 20462 (1 page)
- Lakewood watts link 20505 (2 pages)
- Lakewood REPLACEMENT HARDWARE KIT FOR 20536 LADDER BARS (1 page)
- Lakewood REAR UPPER CONTROL ARMS 21101_21102_21103 (2 pages)
- Lakewood SUSPENSION BARS 21150 (2 pages)
- Lakewood Qwik Links 21200_21201_21202 (1 page)
- Lakewood LIFT BARS 21312_21313 (4 pages)
- Lakewood LIFT BARS 21314 (4 pages)
- Lakewood LIFT BARS 21700 (4 pages)
- Lakewood traction bars 21715 (2 pages)
- Lakewood traction bars 21720 (2 pages)