Mallory Ignition Lakewood traction bars 50200 - Manual (Page 2)

2
LAKEWOOD IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144 • 216.688.8300 • www.mrgasket.com
FORM 97140078
09/03
Made in U.S.A.
Printed in U.S.A.
Fig. #1 Fig. #2
Fig. #3 Fig. #4
Fig. #5 Fig. #6
FRONT OF CAR
FRONT PASSENGER SIDE FRONT DRIVER SIDE
you will need to adjust them according to your
car’s suspension setup. Pre-loading the bars will
not only prevent wheel hop, but will also slightly
change front wheel alignment. Generally, loading
the bars will increase the amount of tow out. We
suggest only a few turns for street use. Be sure to
keep rod-end threads oiled for easy adjusting.
NOTE: Prolonged use of a heavy race-load may
cause premature tire wear.
IMPORTANT!
Periodically check to make sure that all mounting
hardware is securely tightened. Use a good
quality chassis grease to keep bushings and
sleeves properly lubricated.
TECHNICAL SERVICE
A highly trained technical service department is
maintained by Lakewood Industries to answer your
technical questions, provide additional product
information and offer various recommendations.
See your local retailer of Lakewood products for
specific prices. For best results, technical service
calls, correspondence and warranty questions
should be directed to the following address:
Lakewood Industries
10601 Memphis Ave. #12
Cleveland, Ohio 44144
Phone 216-688-8300
8:30 A.M.-5:00 P.M. EST
www.mrgasket.com
RETAIN THIS INSTRUCTION SHEET
FOR FUTURE REFERENCE