Mallory Ignition Lakewood traction bars 21715 - Manual (Page 2)

snubber clearance gap should be increased. For a firm
competition ride, the snubber clearance gap can be
decreased. If vehicle torque steers (pulls to right or left)
under acceleration due to traction bars, the
snubber clearance gap can be adjusted to eliminate this
problem.
To correct unequal traction, try the following:
a) Be sure that both tire pressures are equal.
b) If vehicle torque steers to the right under
acceleration, decrease the gap on the right
side bar.
c) If vehicle torque steers to the left under
acceleration, decrease the gap on the left
side bar.
REPLACEMENT PARTS
Urethane Snubbers (2/set) . . . . . . . .#20700
Rubber Snubbers
(2/set) . . . . . . . .#20530
TECHNICAL SERVICE
A highly trained technical service department is
maintained by Lakewood Industries to answer your
technical questions, provide additional product
information and offer various recommendations. See
your local retailer of Lakewood products for specific
prices. Technical service calls, correspondence and
warranty questions should be directed to the
following address:
Lakewood Industries
10601 Memphis Ave. #12
Cleveland, Ohio 44144
Phone 216-688-8300 ext. 500
8:30 A.M.-12:00 P.M., 1:00 P.M.-5:00 P.M. EST
www.mrgasket.com
RETAIN THIS INSTRUCTION SHEET
FOR FUTURE REFERENCE.
P/N 97144059
Rear bracket with mounting clamp on top of spring. Position bar to allow adequate clearance around
brake lines, parking brake cable, etc.
Locate snubber under front spring eye.