Mallory Ignition Lakewood SUSPENSION BARS 21150 - Manual (Page 2)

www.lakewood-industries.com LAKEWOOD 2
STEP 13
Run the jam nuts up on all the 3/8” “U” bolts that are supplied with
the kit.
STEP 14
Position the “U” bolts all over the spring and through the strap on the
top of each bar. Run the lower nuts up on the “U” bolts. Lock with
upper jam nuts. Do not attempt to adjust bar height with “U” bolts.
RECOMMENDED STARTING ADJUSTMENTS
1. Be sure that both tire pressures are equal.
2. To correct unequal traction, try the following: If the rear
drives harder with the right wheel, raise the left bumper or
move it forward.
NOTE: When properly installed, snubber end of traction bar must angle
up or be parallel with chassis: under no circumstances should vehicle be
operated with snubber end angled down. If bar cannot be further adjusted,
use one of Lakewoods suspension bar kits no. 20500, 20502, 20504, or
20510, depending on application.
Lakewood chassis and suspension products are engineered and
manufactured to improve the performance of your vehicle. We
encourage you to enjoy using our products safely at a sanctioned
racing facility. Please obey all traffic laws.
LAKEWOOD IS A TRADEMARK OF PRESTOLITE PERFORMANCE
10601 MEMPHIS AVE #12, CLEVELAND, OH 44144
216.688.8300
FAX 216.688.8306
FORM 9744065
07/11
Figure 1
ASSEMBLY INSTRUCTIONS
Typical 21000 Series Traction Bar with 20580 “J” Bolt Option
Figure 2