Mallory Ignition Lakewood safety bellhousing starter 15320_15330 - Manual (Page 2)

“B” SET UP (BLOCKPLATE)
7. Remove knockout from blockplate.
8. Install starter adapter in outer starter pilot hole.
Be sure adapter is seated and bolt does not
protrude past adapter. Use Diagram B.
9. Install blockplate on engine.
10. Install flywheel, clutch cover and disc.
11. Install Lakewood unit to engine using Bolt
Package #635 and #638.
12. Install starter carefully as the aluminum casting
can be misaligned and damaged. Use Bolt
Package #628 and Diagram B for proper bolt
installation.
“C” SET UP (BLOCKPLATE)
7. Install starter adapter in inner pilot hole. Be sure
adapter is seated and bolt does not protrude
past adapter.
8. Install blockplate on engine.
9. Install flywheel, clutch cover and disc.
10. Install Lakewood unit to your engine. Be sure to
use the throw-out bearing. Use Bolt Package
#635 and #638.
11. Install starter carefully as the aluminum casting
can be misaligned and damaged. Using Bolt
Package #628, install top bolt first. Rotate bottom
of starter as close to the block as possible. Make
sure holes are aligned before installing clamp bolt.
LAKEWOOD IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144 • 216.688.8300 • www.lakewood-industries.com
FORM 97140081
07/04
Made in U.S.A.
Printed in U.S.A.