Mallory Ignition Mallory COMP 9000™ 90 SERIES POINT TYPE DISTRIBUTOR - Manual (Page 2)

MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
550 MALLORY WAY, CARSON CITY, NEVADA 89701
(775) 882-6600 FAX (775) 887-4326
www.mrgasket.com
FORM #641
(REV. B) 9/99
Made in U.S.A.
Printed in U.S.A.
MALLORY COMP 9000™ DISTRIBUTOR
90 SERIES POINT TYPE
TUNE-UP AND MAINTENANCE INFORMATION
NOTE: Turning wrench
clockwise increases
dwell angle.
POINT NO. 1
Both the red point harness lead and the orange condensor lead
must connect to this point when distributor is in this point.
POINT NO. 2
Connect black point harness lead only to
this point to ensure proper distributor ad-
justment and performance.
IMPORTANT: Apply a light
film of Mallory distributor
cam grease (supplied) on
surface of cam to extend
point life.
MALLORY COMP 9000™
POINT ADJUSTMENT PROCEDURE
NOTE: If dwell meter is not available, set each
point gap at .018 – .020
OR
With connector unplugged, using the 8-cyl scale
on your dwell meter, adjust the setting to read
26º – 28º dwell angle. Proceed to Step 2 to attain
total dwell setting.
After reinserting plug connector, adjust the sec-
ond set of points to the total dwell angle setting
of 34º – 36º, again using the 6-cyl scale on your
dwell meter.
Once these two steps have been completed, you
must reset your ignition timing.
NOTE: Turning wrench
clockwise increases
dwell angle.