Luminex No Top Plate (NTP) Swivel Base Installation and User Manual User Manual
Page 17

7
Using the NTP Swivel Base
FIGURE 6.
Swivel Base, Side View
To move the middle section to the left or right:
1.
Pull both the front and back slide knobs slightly outward.
2.
Rotate each knob about one-quarter turn and release it. The middle section is now
disengaged and can move right and left, carrying the top plate with it.
3.
Move the middle section as necessary. The middle section can only be locked into
place when it is fully extended or retracted.
4.
Pull one of the knobs slightly outward.
5.
Rotate the knob about one-quarter turn or until you feel the knob pull in and lock into
place. The middle section is now locked into place.
FIGURE 7.
Swivel Base with Middle Section Extended to Right
FIGURE 8.
Swivel Base with Middle Section Retracted to Left
1
Front and back swivel knobs
2
Front and back slide knobs
1
2