Magnum Venus Plastech High Volume Pro Gun 60625-1 - Manual (Page 34)

High Volume Pro Gun Manual
Rev. 05/2012 Page | 34
Actuator Rebuild:
Actuator Disassembly
1. Remove the end cap from both ends of the cylinder body.
2.
Push the actuator piston out the back of the cylinder body.
3. Replace the o-ring (O-V-133) on the actuator piston.
4. Check the actuator bushing and cylinder body for wear or damage.
5. Apply a light film of Pro Gun Oil (04394) to both the inside of the cylinder and
actuator piston.
6. Install the actuator piston into the cylinder body, the actuator bushing should go
in first and be off center towards the top.
7. Install the end cap onto both ends of the cylinder body.
CYLINDER BODY
PISTON BODY
END CAP
END CAP
O-RING
ACTUATOR BUSHING
ACTUATOR SEAL