Magnum Venus Plastech High Volume Pro Gun 60625-1 - Manual (Page 29)

High Volume Pro Gun Manual
Rev. 05/2012 Page | 29
Tighten Packing Nuts
1. Tighten both the resin and the catalyst packing nuts. Do not damage the packing
bit
2.
Move the actuating stem back and forth, opening and closing the gun.
3.
Again tighten both the resin and the catalyst packing nuts.
4. Repeat the above tightening process one more time
Reinstall Hose Fittings
1. Reinstall the fitting and o-ring for the resin hose on the rear of the gun block.
2. Reinstall the catalyst fitting and o-ring on the rear of the gun block
Reinstall Check Valve on International Pro Guns
DANGER: To replace this valve, contact Magnum Venus Products. These valves
have undergone specific remanufacture at Magnum Venus Products for the Pro
Gun ™. Using a check valve not obtained directly from Magnum Venus Products
may result in contamination and /or dangerous ignition of the catalyst.
1. Reinstall the check valve (5104-04-01) and o-ring (O-S-5-125) on the front side
port on the catalyst side of the gun block.
Or
Reinstall Catalyst Plug on Domestic Pro Guns
2. Thread the catalyst plug (5104-32-1) into the front side port on the catalyst side
of the gun block