Magnum Venus Plastech High Volume Pro Gun 60625-1 - Manual (Page 32)

High Volume Pro Gun Manual
Rev. 05/2012 Page | 32
SCREW
MIX HOUSING
DISTRIBUTION RING
MIX HOUSING SEAL
INJECTOR ASSEMBLY
HV TURBULENT MIXER
HV NOZZLE ADAPTOR
NOZZLE SEAL
NOZZLE
NOZZLE CAP
Assemble Mix Housing
1. Install the distribution ring (58133-1) into the mix housing
Note: Be sure the holes in the distribution ring are clean and free of debris or
hardened material.
2. Position the mix housing seal into the mix housing, against the distribution ring.
3. Insert the catalyst injector assembly (58115-1) and injector seal into the center
hole of the distribution ring. The spring should be facing up, as it will go into the
gun block and the injector seal will be against the gun block.
4. Use the socket cap screws (F-CS-05F-16-GR8) to attach the mix housing to the
gun block
WARNING: Screws and fasteners provided with this Pro Gun™ are specially
designed for this equipment. Use only Magnum Venus Product replacement
parts, or warranty may be voided.
5. Insert the turbulent mixer into the mix housing.
6. Apply some red grease to the threads of the mix housing and nozzle cap. This
will make them easier to remove later.
7. Install HV nozzle adaptor to the mix chamber.
8. Install the nozzle into the nozzle cap.
9. Screw the nozzle and nozzle cap onto the mix housing.