Magnum Venus Plastech SUPER PRO GUN II User Manual
Page 28
SUPER PRO GUN &
SUPER PRO GUN II
23
NOTE
Discard all parts to be replaced by repair kit. All remaining parts should be
thoroughly cleaned, inspected for damage, and replaced if necessary.
NOTE
Seal Assembly consists of; two 5104-7-1 (Packing Rings), two 5104-4-1
(Relief Spacers), two 5104-3-1 (Secondary Seals), One 5104-6-1 (Teflon
Catalyst Seal), and one 5104-5-1 (Teflon Resin Seal).
13. Using the 9301-5-1 (Seal Installation Tool), force the Seal
Assembly out of the Gun Block.
Flush Valve Disassembly Procedures:
1.
Remove and discard the 5104-21-1 (Flush Valve Split Seal) from
the 5104-24-1 (Flush Valve Body).
2.
Remove the 5104-02-01 (Flush Elbow Assembly) from 5104-22-1
(Flush Valve Neck).
3.
Remove the 5104-22-1 (Flush Valve Neck) and 5104-26-1 (Flush
Valve Seal) from the 5104-24-1 (Flush Valve Body). Discard the
5104-26-1 (Flush Valve Seal).
4.
Remove the 5104-23-1 (Flush Seal Body) from the 5104-25-1
(Flush Valve Button).
5.
Remove the 9203-2-3 (Compression Spring) from the
5104-24-1(Flush Valve Body).
6.
Remove and discard the 7301-3-007 (O-Ring) from the 5104-23-1
(Flush Seal Body).
7.
Remove and discard the 7301-11-008 (O-Ring) from the
5104-25-1 (Flush Valve Button).