beautypg.com

Fig. 3.6 – Magnum Venus Plastech SUPER PRO GUN II User Manual

Page 16

background image

SUPER PRO GUN &

SUPER PRO GUN II

Fig. 3.6

18. Install the 5104-2-1 (Valve Rod) through the resin side of the gun.

Use the 9301-5-1 (Seal Installation Tool) to center the Valve Rod
in the 5104-1-1 (Gun Block).

19. Install and hand tighten the 5104-8-1 (Packing Nut) onto the resin

side of the 5401-1-1 (Gun Block).

NOTE

Make sure that the Valve Rod is correctly aligned; the larger hole goes on the
resin side, while the smaller hole goes on the catalyst side. See Fig. 3.6.

NOTE

The middle hole, into which the actuating stem will be inserted, must also be
correctly aligned. One end of the hole has a relief in the threads, which
should face down. See Fig. 3.6.

11

This manual is related to the following products:
See also other documents in the category Magnum Venus Plastech Equipment: