Magnum Venus Plastech CB-6000-RGT Metric Units PROGRAMMING - Manual (Page 7)

6
be highlighted. By pushing the INCREMENT/ON or the
DECREMENT/OFF buttons you can increase or decrease the value of
the highlighted digit. Pushing the Right Cursor button will move the
highlighted digit to the right. This value is normally left at 0000.0.
Step 5) Push the Down Cursor button again and the display will change
to this:
This is the low limit for the alarm function. The setting procedure and the
preferred setting are the same as in step 4 above.
Step 6) Push the Down Cursor button again and the display will change
to this:
You can now set the decimal point position for your calibration number.
Normally a 3 place decimal is satisfactory but if you have a calibration
number that is less than 10 (see chart) change this to a 4 place decimal by
using the Right Cursor button to increase or decrease this decimal
point.
Step 7) Pushing the Down Cursor again will change the display to look
like this: