Magnum Venus Plastech CB-6000-RGT Metric Units PROGRAMMING - Manual (Page 6)

5
Step 1) Turn the front panel power switch off.
Step 2) Connect power (100 to 125 VAC, 50/60 Hz, 6 VA) to the unit and turn
the power switch on. The initial rate meter display should look like this:
Step 3) Push the RUN/PROGRAM button. The display should now look
like this:
This indicates that you are now in the "Program" mode and are now able to
change the decimal point reading on the unit's display. Pushing the Right
Cursor button will change the decimal point to as many as 4 places
(.0000) or no places (0). It is recommended that a 1 place decimal (.0) be
used.
Step 4) Push the Down Cursor button and your display should now
look like this:
This number is the high limit for an alarm function. When the display
reaches this number (or greater) a connection is made inside the unit and a
.5 VDC current is available at the output terminals at the rear of the unit. To
change this value, push the Right Cursor button and the first digit will