Magnum Venus Plastech RT-1000 PUSH BUTTON TRIGGER - Manual (Page 21)

RT-1000 Remote Trigger Manual
Rev. 12/2012 Page | 21
Pre-Start Checklist
ACTIVITIES MUST BE DONE IN THE SEQUENCE SHOWN, AND MUST BE CHECKED OFF
AS COMPLETED. USE THIS CHECKLIST IN CONJUNCTION WITH THE OPERATING
MANUAL FOR THE ULTRAMAX UNIT.
ACTIVITY
Priority: Put on Respirator as specified for spray painting, Protective Clothing, Eye
Protection, and PVC Gloves
1 Tools and materials are available for pre-start checks.
2 Incoming airline is ½ inch.
3 Incoming airline is connected to the inlet manifold.
4 Earth straps are connected to the resin drum and to earth.
5 Incoming air valve is in the OPEN position.
6 Air supply is ON.
7 At the Manifold, open the air supply to the gun.
8 Seat the catalyst and resin seals on the Pro Gun.
9 Compress the resin pump packing.
10 Check for oil in the pump reservoir.
11 Adjust the Catalyst Pump Packing Nut.
12 Check that there is Catalyst in the Catalyst Bottle.
13 Check that the Catalyst Bottle Cap is in place.
14 Place the Resin Pick-up wand in the resin supply container.
15 Place the end of the Resin Return Hose in the resin container.
16 Fill the Solvent Flush Tank.
17 At the Manifold, turn the Air Pressure on to the Solvent Flush Tank (50 – 60psi)
18 Flush the mix chamber on the Pro Gun.
19 Remove air from the Catalyst feed line to the Catalyst Pump.
20 Close the ball valve below the Surge Chamber.
THE UNIT IS NOW READY TO BE STARTED UP.
ABNORMAL CONDITIONS OBSERVED AND CORRECTED
Abnormal Condition
a a a a when
corrected
OPERATORS NAME: ___________________________________ DATE: _______________
SIGN OFF WHEN START UP CHECKS ARE COMPLETED: _______________________