Magnum Venus Plastech Powerhead Powerslide VPH-2500 - Manual (Page 10)

Powerslide Powerhead
Powerslide Powerhead
Pilot Valve Rebuild
Chapter
5
NOTE
The two pilot valves in the upper and lower end caps are the same. Start
with the pilot valve in the upper end cap.
1. Remove the inlet spring housing (MPH-2509) from the upper end cap (MPH-
2508). Remove spring (MPH-2533) with inlet rod (MPH-2514). Turn the end
cap over and a small spring (MPH-2526) will fall out. (See Figure 5) Replace
O-ring (O-B-012) on the spring housing (MPH-2509) and the O-ring (O-B-006)
on the inlet rod (MPH-2514). Coat O-rings and springs with lithium grease. Set
spring (MPH-2533) into the spring housing (MPH-2509) with inlet rod (MPH-
2514) facing up.
Figure 5
The MPH-2526 spring
will be installed from the
bottom of the end cap.
MPH-2526 Spring