Magnum Venus Plastech Powerhead Powerslide 7000 Series - Manual (Page 17)

MAGNUM VENUS PLASTECH Powerslide Dual Rod 17
6. Insert the Diaphragms (MPH-5010) into the Upper and Lower Valve Blocks
with the outside leading edge of the Diaphragms facing out. Push the
Diaphragms all the way down into the Valve Block bore.
7. Install the Valve Exhausts (MPH-5009) onto the Upper and Lower Valve
Blocks. One side of the Valve Exhausts has three holes, one of the holes
must line up with the machined holes in the Upper and Lower Valve Block.
(See Figure 4)
Figure 4:
Do not block the hole in the valve block when
installing the valve exhaust.
8. Install the two Socket Head Cap Screws (FCS- 04C-08-SS) into each of the
two Valve Exhausts and snug tight.
9. Install Valve End Caps (MPH-2521) into the Upper and Lower Valve Blocks
and lightly snug.
Do not block hole