Magnum Venus Plastech Flex Molding Process IVx3 MODULE 8018 - Manual (Page 15)

Vacuum Valve Service Module Manual
Rev. 10/2012 Page | 15
Introduction:
This Vacuum Service Module is an air driven unit which allows users of the PPVS,
PPVS-Infusion and AutoCatch to easily check and adjust the switching point of these
control valves. It also allows for testing for vacuum leaks in the IVx3, IVx2, TAS and
TAS-14 Injection valves.
The Calibration Box’s internal vacuum can be adjusted infinitely between atmosphere
and minus 800mb.
8018 – IVx3 SERVICE MODULE has the following features:
1. Universal insert for vacuum integrity testing.
2. Adjustable vacuum level.
3. Vacuum isolation valve.
4. Pressure indicator (for PPVS testing etc.).
5. Three position selector valve to control outputs to inject and purge ports.
6. Air out port.
7. Internal regulator set at 6 bar for control signals and air out port.
8. Air leak signal outputs (this can be used to test PPVS-1000 etc.).
9. Some fittings and tubing supplied attached to the box, so no additional items
required for most tests.