beautypg.com

Alto-Shaam ECOSMART HFT2SYS-400 User Manual

Page 5

background image

HFT2 INSTALLATION/OPERATION/SERVICE MANUAL • 3 .

s i t e i N s t A L L A t i O N

i N s t A L L A t i O N

s i t e i N s t A L L A t i O N

In order to maintain

established National

Sanitation Foundation

standards, all stationary

floor models must be

sealed to the floor with a

R.T.V. or silastic meeting

N.S.F. requirements or

have 6" (153mm)

unobstructed clearance

beneath the unit.
1. The appliance must be

installed on a stable

and level surface.

2. DO NOT install this appliance in any area

where it may be affected by any adverse

conditions such as steam, grease, dripping water,

high temperatures, or any other severely

adverse conditions.

3. DO NOT install a heated display case near a cold

air source such as a freezer, air conditioning vents,

or in any area where outside air fluctuation can

affect performance.

4. This appliance must be kept free and clear of

any obstructions blocking access for

maintenance or service.

A number of adjustments are associated with

initial installation and start-up. It is important

that these adjustments be conducted by a

qualified service technician. Installation and

start-up adjustments are the responsibility of the

dealer or user. These adjustments include but

are not limited to thermostat calibration, door

adjustment, leveling, electrical hook-up and

installation of optional casters or legs.

LeVeLiNG

Level the appliance from side-to-side and

front-to-back with the use of a spirit level.
We recommend checking the level periodically

to make certain the floor has not shifted nor the

appliance moved.
NOte:

Failure to properly level this appliance

can cause improper function.

®

D A N G e R

impROpeR inStallatiOn,
alteRatiOn, adJUStment,
SeRviCe, OR maintenanCe COUld
ReSUlt in SeveRe inJURY, deatH,
OR CaUSe pROpeRtY damage.
Read tHe inStallatiOn,
OpeRating and maintenanCe
inStRUCtiOnS tHOROUgHlY
beFORe inStalling OR SeRviCing
tHiS eQUipment.

C A u t i O N

metal paRtS OF tHiS eQUipment
beCOme eXtRemelY HOt WHen
in OpeRatiOn. tO avOid bURnS,
alWaYS USe Hand pROteCtiOn
WHen OpeRating tHiS applianCe.

C A u t i O N

tO pRevent peRSOnal inJURY,

USe CaUtiOn WHen mOving OR

leveling tHiS applianCe.

C A u t i O N

The performance of this unit has
been optimized using the factory
provided bulbs. These bulbs should
be replaced with an exact replacement
or with a factory recommended
replacement. These bulbs have been
treated to resist breakage and must be
replaced with similarly treated bulbs in
order to maintain compliance with NSF
standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb fi lament.