Lectrosonics Quadra User Manual
Page 23
Digital IEM System
7. Attach the antenna wires to the antenna ports on
the back of the transmitters.
8. Attach the supplied antenna cable protectors to the
sides of the transmitters right behind the rack ears.
Secure them with the supplied screws.
Note: This part will fit tightly and is meant to
deform slightly during installation t maintain
pressure on the coaxial connector.
The dual set of M4T transmitters is now ready for rack
mounting.
Rio Rancho, NM
23
See also other documents in the category Lectrosonics Equipment:
- R400a (24 pages)
- SRb_SRb5P (28 pages)
- UCR100 (12 pages)
- UCR401 (28 pages)
- UCR411a (28 pages)
- Venue Series (Wideband) (32 pages)
- VR Field (Wideband) (32 pages)
- D4 System (20 pages)
- R1a (12 pages)
- CR170 (11 pages)
- CR175 (12 pages)
- CR185 (12 pages)
- CR185-CL (1 page)
- CR187 (12 pages)
- CR195 (16 pages)
- DR175 (10 pages)
- DR175NC (10 pages)
- DR185 (12 pages)
- R170 (13 pages)
- R172 (13 pages)
- R175 (10 pages)
- R175CL (1 page)
- R176 (4 pages)
- R185 (12 pages)
- R400 (24 pages)
- SR170AC (10 pages)
- SR170LE (2 pages)
- SR175 (10 pages)
- SRa Series (28 pages)
- UCR110 (10 pages)
- UCR190 (12 pages)
- UCR195D (16 pages)
- UCR200d (14 pages)
- UCR201 (20 pages)
- UCR205d (14 pages)
- UCR210d (14 pages)
- UCR211 (20 pages)
- UCR300 (14 pages)
- UCR310 (14 pages)
- UCR411 (16 pages)
- UCR511 (28 pages)
- UDR195 (18 pages)
- UDR200a (12 pages)
- UDR200b (22 pages)
- UDR200c (26 pages)