Impulse 2123 - Manual (Page 7)

Hardware Installation
Do not connect the device to a USB port until the
software has been successfully installed.
To install the 2123, plug the device into an available USB port using the supplied
USB cable. The following instructions were tested with Windows XP and may vary
based on your version of Windows.
Once the device has been connected, the Found New Hardware wizard will appear
first for the root hub and then for each port that you are installing. Follow the
instructions on the following page to finish installation.
The installation will repeat twice for the COM port.
This is a limitation in the way Windows installs
external serial devices.
1. Click on ‘Install the software automatically’ followed by the ‘Next’ button.
2. Windows will show a warning message that the hardware has not passed
Windows logo testing. Click on ‘Continue Anyway’.
Note: all applications and drivers have been fully tested to maintain the
integrity of your operating system. Clicking on ‘Continue anyway’ will not
harm your system in any way.
3. Click on ‘Finish’.
© Sealevel Systems, Inc. - 5 - SeaLINK.SC User Manual