Impulse 2103 - Manual (Page 5)

Installation
Sealevel Systems SeaLINK+232I Page 2
Installation
Operating System Installation
Please note that you should install the software before installing the hardware.
Choose Install Software at the beginning of the CD and select the Serial I/O
software drivers and install SeaCOM.
System Installation
The screen captures below are taken from a Windows ME installation. Your
particular operating system may differ slightly from what is shown based on
your version of Windows.
The SeaLINK+232I can be connected to any Upstream Type “A” port either at
the PC host or an Upstream Hub. The SeaLINK+232I is hot-pluggable,
meaning there is no need to power down your computer prior to installation.
The SeaLINK+232I requires no user hardware configuration since there are no
jumpers present on the card.
1. After installing the software connect SeaLINK+232I to an Upstream Host
or Hub.
This indicates that the system has recognized the new device and will now
proceed to locate a driver.