7 standards, 8 equipment versions – ADS-TEC VMT6010/6012/6015 User Manual
Page 6

VMT6010/6012/6015
5
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
1.7 Standards
This device complies with the requirements and protective aims of the following EC regulations:
Standards
This device meets the test requirements for granting the CE sign according to the
European test standards EN 61000‐6‐4 and EN 61000‐6‐2
This device complies with the test requirements in accordance with EN 60950
(VDE0805, IEC950) "Safety of Information Technology Equipment"
The device meets the EN 60068‐2‐6 test requirements (sinus excitation).
This device meets the EN 60068‐2‐27 test requirements (shock resistance test)
Note:
A respective conformity declaration for the authority in charge is available at the
manufacturer and may be viewed on request.
All connected components, as well as cable connections must also meet these
requirements for compliance with the EMC legislation. For this reason, screened
bus and LAN cables including screened connectors must be used and installed
according to the instructions in this user manual.
Note:
By using the CE conformity declaration in this document, you can find detailed
information about the standards applicable to this device.
Warning:
This is equipment of class A. This unit might cause radio interferences in living
areas; in this case the operator might be obliged to take suitable protective
measures at the operator’s expense
1.8 Equipment Versions
The system is available in two equipment versions:
Platform including a Flash SSD:
Platform without any rotating mass storage medium (hard disc, etc.) and with an embedded operating system
(Windows CE 6.0 / XP embedded) for stationary use with a standard Ethernet or with radio networking cards
installed on moving commissioning / forklift equipment.
Platform including a hard disc:
Equipped with a hard disc for stationary use, e.g. in the manufacturing department using a standard operating
system.