8 software‐/driver‐installation – ADS-TEC VMT6008 User Manual
Page 32

VMT6008
31
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
8 Software‐/Driver‐Installation
The device will be delivered with a pre‐installed Windows / Linux operating system depending on what the
customer wants. The drivers required for this are already installed and the operating system will be enabled by
entering the licence information. Should an initial installation be required, please follow the following steps. With
a newer operating system like Windows XP, the network card and graphics card will properly be recognised
during the initial installation, so that only the touch screen driver and the soft keyboard must be installed
separately.
Note:
If the hard drive was formatted, the operating system can be reinstalled by using one of
the existing interfaces.
An external keyboard is required for installation.
Installation of the Operating System
The device does not have any integrated CD drive. The installation of the operating system can therefore only be
carried out by using the USB interface.
Procedure for installation
The boot drive in the system Bios must be switched to USB in order to boot the
device from the USB interface.
Restart the device and insert a Windows CD.
Install Windows and set up the basic data.
With devices including touch screens, the touch screen driver as well as the soft
keyboard should be installed in order to ensure their full functionality.
With Windows CE 6.0 or Windows XP embedded, a complete image can also be installed by using a USB stick.
Pos: 37 /Datentechnik/Software / Treiber Installation/Touch Screen/Touch Screen Installation für OPC 5112/5212/5315/5515/5317/5319 / CPC5006/OTC5006/ VMT-Serie @ 0\mod_1159175108636_6.doc @ 665 @