Controlled Products Systems Group 4300SW - Manual (Page 22)

20
20 - MAINTENANCE SCHEDULE - APOLLO GATE OPENER
Active the primary (inherent)reverse system by blocking the gate with a solid object. The
gate should reverse momentarily then stop. Restart the gate snd block again with a solid
object. The gate should reverse momentarily, then stop, and go into hard shutdown with
an alarm
If operator is equipped with option DC backup system, check to be sure the system
opens the gate upon loss of AC power
If operator is equipped with option DC backup system, check the batteries for any
leakage or loose connections. Batteries should be replaced every two years
Check emergency vehicle access device for proper operation
Check that the gate reverses on contact with an object in both the opening and closing
cycles
Check vehicular reverse and shadow loops for proper operation
Check manual release for proper operation
Overall Check: Complete check of gate and gate operating system
Check screws and nuts
Remove top lid and sweep out any debris or dust that may have accumulated.
Every 6 months
Alarm
Backup System
Battery
Fire Dept
Reverse System
Loop(s)
Release
Complete
Mounting Hardware
Rain Drain
COMPLETE
●
●
●
●
●
●
●
●
●
●
BASIC
●
●
●
●
●
Table 2
Figure 29 - INSTALLATION DRAWING
21 - INSTALLATION DRAWING (1)
Gate Arm Attachment
Sample installation
14” 24”
10”
20”
39”
33
1/2”
24”
POST POST
LONG ARM
SHORT ARM