Controlled Products Systems Group 1603-080 - Manual (Page 14)

1603-065-A-10-06 14 installation guide
electrical installation/gate tracker wiring
1 2 3 4 5 6 7 8 9 10 11 12 13 14
SW1
S W2
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
3- DATA OUT
2- DATA IN
1- COMMON
"ELDEN
OR
#ONSOLIDATED
0
4O
3- DATA OUT
2- DATA IN
1- COMMON
The operator will report status to the DoorKing Access Control System (1833, 1835, 1837 and 1838) that is equipped with a Tracker expan-
sion board. This report includes operator cycle count, shorted inputs, loop detector problems, power interruptions, etc.
Maximum wire run for tracker board is 500 feet using Belden #9931 shielded cable or Consolidated #5324-CL
shielded cable. Float the shield at the tracker board. Do not connect the shield to the tracker board common.
Wire connection from the tracker board terminal P1-6 to the terminal 6 is optional if the barrier operator is not
to be activated by the tracker output relay.
For more detailed information on Gate Tracker™ and wiring to the Tracker expansion boards, refer to the
Tracker Installation and Wiring Manual, DoorKing P/N 2351-010.
1
2
1
Connect the wiring from the auxiliary terminal
strip located on the left side of the circuit board
to the Gate Tracker™.
Connect the wiring from terminals 5, 6 and 14
on the main terminal strip to the Gate Tracker™.
2