beautypg.com

Important notices – Controlled Products Systems Group 1504-080 User Manual

Page 6

background image

2.15

IMPORTANT NOTICES

• Prior to starting the installation, become familiar with the instructions, illustrations and wiring

diagrams in this manual.

• Never mount this device to a moving gate or gate panel, or next to a gate that causes

vibration to the fence, such as a spring-loaded pedestrian gate. Continuous vibration from
moving or slamming gates can cause damage to the unit in time.

WARNING! If this entry system is used to control a vehicular gate with

an automatic gate operator, the entry system must be mounted a
minimum of ten (10) feet away from the gate and gate operator, or in
such a way that a person cannot operate the entry system and touch
the gate or gate operator at the same time.

• Always disconnect power when performing service on the system.
• If the unit is mounted outdoors, be sure that the wiring to the unit is designed for direct under-

ground burial, even if the wire is run inside a conduit.

• Surge suppression is recommended on the low voltage input power line.
• Instruct the end user on the safe and proper operation of this device.
Instruct the end user to read and follow these instructions. Instruct the end user to

never let children play with or operate any access control device. This Owner’s
Manual is the property of the end user and must be left with them when installation is
complete
.

Page 6

1506-065-D-1-09