A799 - diagnostics form – CognitiveTPG A799 User Manual
Page 25

Chapter 4: Using the Printer
25
11/2012
A799-UG00001 Rev. D
A799 Two-Color Thermal Receipt Printer: User Guide
Print test and Configuration menu samples. Samples will vary depending on the printer model.
(Shown approximately 60% of size)
Short clicks are used in the main menu selections.
- Set Firmware Features - > 8 clicks
*** A799 - Diagnostics Form ***
Model number : A799-120D-TD00
Serial number
: 0000000000
Boot Firmware
Revision
: V3.02
CRC
: 7E22
P/N
: 189-7940489B
Flash Firmware
Revision
: V3.01
CRC
: 4448
P/N
: 189-7940490A
H/W parameters
Flash Memory Size
: 4 Mbytes
Flash Logos/Fonts
: 1024 kbytes
Flash User Storage
: 960 kbytes
Flash Perm’nt Fonts
: 960 kbytes
Flash Journal Size
: 128 kbytes
SRAM Size
: 512 kbytes
Head settting
: D
Motor ID
: 1
Paper Type Setting
: Type 0, Monochrome
Color Density Adj
: n/a
Print Density, Mono
: 100%
Max Speed
: 250 mm/sec
Paper Width
: 80 mm
Max Power
: 55 W
Knife
: Enabled
Partial Cut
: 125 steps
Paper Low Sensor
: Enabled
No Paper Low Extension
Comm. Interface
RX Buffer Size
: 4096
Interface Type
: RS232/USB
Parameters
Baud Rate
: 115200
Data Bits
: 8
Stop Bit
: 1
Parity
: NONE
Flow Control
: DTR/DSR
Reception Errors
: Ignore
USB Driver Type
: Printer Class
USB Packet w/Error
: Reject
When the printer is configured for USB, this
location will show either: “USB Driver Type: Native”,
“USB Driver Type: Printer Class”, or “USB Driver:
Comm Class.”