Aiwa XR-EM50 - Manual (Page 4)

4
En
Remote control
Detach the battery compartment lid at the rear of the remote
control and insert two R6 (size AA) batteries with correct
polarity.
R6(AA)
•Replace the batteries with new ones when the operational
distance between the remote control and main unit becomes
shorter.
•Remove the batteries if the unit is not going to be used for
an extended period of time.
•The remote control may not operate if it is used under intense
sunlight or if its line of sight is obstructed.
Connection
Plug in the AC power cord to the AC outlet after all other
connections are made.
1 Connect the speakers to the main unit.
Connect the right speaker to the SPEAKERS R terminals
and the left to the SPEAKERS L terminals. The speaker
cords with the stripes go to the
terminals.
2 Connect the supplied antennas.
Connect the FM antenna to the FM 75
Ω
terminal and the
AM antenna to the AM LOOP jack. Connect the FM antenna
to the FM 75
Ω
terminal without the 2 mark, as illustrated.
FM antenna AM antenna
PREPARATIONS
3 Connect the AC power cord to an AC outlet.
The clock will flash on the display.
For setting the clock, see page 7.
Speakers
•Do not short-circuit the
and speaker cord leads.
•Do not leave objects generating magnetism or objects
affected by magnetism near the speakers.
Antennas
Keep antennas away from metallic objects, electrical
equipment and cords.
•FM antenna: Extend fully and position for the best
reception. If reception is poor, connect an optional outdoor
antenna to the FM 75
Ω
terminals. When connecting an
optional outdoor antenna, be sure to connect the shield braid
of the antenna to the 2 terminal.
•AM antenna: Rotate to find best reception.