CNB IDC4000T - Manual (Page 8)

XNET Network Dome Camera Installation Manual
8 / 16
2.3.3. Connecting to Alarm Devices
z
Alarm Input
Wires from various sensor type (IR, heat, and magnetic) can be connected to Alarm in (+)/ (-)
terminal as shown in figure 2.5. (NC or NO of sensor input can be selected at Menu screen.)
Alarm Sensor device requires a separate power source.
Figure 2-4.
z Alarm Output
This terminal can only be connected up to AC 30V/400mA or DC 30V/400mA. An additional relay
device has to be used to control higher voltage or current.
Figure 2-5.