Cleveland Motion Controls ULTRA SERIES CARTRIDGE TRANSDUCER REV AA - Manual (Page 5)

MAN-70251 R EV . AA U LTRA S ERIES S TATIONARY S HAFT T RANSDUCER
P AGE 5 OF 18
1 I
MPORTANT
I
NFORMATION
1.1 O
RDER
N
UMBERS
Use the following example and Tables A, B and C to determine order numbers for:
• Ultra Series Transducers
• Mounting Kits
• Split Bushings
Figure 1 – Example for Determining Transducer, Mounting Kit and Split Bushing Order Numbers
If you needed to Purchase a Transducer, Mounting Kit and Split
Bushing corresponding to following description: Then, you would use Catalog Numbers:
• Size 2 cartridge body.
• Bore diameter of 1.25 in. (to allow direct use of Cleveland-
Kidder split-bushings).
• Side connection (to allow flange mounting).
• Maximum Working Force (MWF) of 150 lbs.
• Bushing to accommodate 3/4 inch (outside diameter) shaft
Ultra Series Transducer = MO-13327-00
Mounting Kit = MO-04498 (Refer to Table B )
Split Bushing = MO-00988-1 (Refer to Table C )
Having the following information at hand will help you to easily determine which of the Ultra Series Cartridge
Transducers for Stationary Shafts is right for your application:
• The desired diameter of the shaft bore
• The type of electrical connection
• Maximum working force
Use Table A to determine the catalog number for the proper Stationary Shaft Transducer.
Table A – Determining a Catalog Number for the Ultra Stationary Shaft Transducer
Order Code Suffix, M.W.F.
Cartridge Size
Bore Diameter
of Shaft
Coupling
(inches)
Side
Connector
(SC)
End
Connector
(EC) -00 -10 -20 -30 -40
1T 1.25 MO-13333 MO-13332
1T 1.50 MO-13335 MO-13334
25 lb 50 lb 75 lb 100 lb 150 lb
2T 1.25 MO-13327 MO-13326
2T 1.50 MO-13329 MO-13328
3T 1.94 MO-13331 MO-13330
150 lb 250 lb 400 lb 600 lb 1000 lb
Metric
Order Code Suffix , Metric M.W.F
Cartridge Size
Shaft
Diameter
(millimeters)
Side
Connection
(SCM)
End
Connection
(ECM)
-00 -10 -20 -30 -40
1T 30 MO-13431 MO-13429 100 N 200 N 350 N 450 N 650 N
2T 30 MO-13432 MO-13430 650 N 1000 N 1800 N 2500 N 4500 N