KT&C KPT-SPDN120HD - Manual (Page 30)

3. Program and Operation
3.10 Auto Scan Menu
▲ / ▼: move joystick up and down for selecting an item.
◀ / ▶: move joystick left and right for moving an item.
▶ / [Open] / [Near]: move joystick right to select or save settings or go to edit pages.
▶ / [Close] / [Far]: move joystick to cancel or to exit current menu (Back).
An {Auto scan} is a PTZ function that can be moved from one position to another position.
The dome has maximum 8 {Auto Scan} and {Scan Speed} can be changed from 1 to 35 degree /
sec. Use the following steps to program a {Auto Scan}.
- Enter into {Main Manu}
- Select {Auto Scan} and move left or right to select {Auto Scan} Number.
- Move the joystick right [▶] to edit {Auto Scan}: {Edit Start Point} / {Edit Stop Point}
- Using the joystick, move to a desired target (Pan / Tilt / Zoom) at screen of
{Edit Start Point} / {Edit Stop Point}
- Press [Near] button or use joystick to save settings.
- Press [Far] button or use joystick to return to previous menu {Scan Setup} (Back).
- To edit and clear the {Scan Title}, refer to Editing a Title section (3.2.1).
- It is possible to clear saved Scan No.xxx in the {Scan setup} Menu individually.
- Set {Dwell Time} using the joystick [▶].
- Press [Open] button or use joystick [▶] to save settings.
- Press [Close] button or use joystick to return to previous menu (Back).
30
SCAN SETUP
NO. 001 : NOT USED
EDIT :
SPEED :
DTIME :
DIRECTION :
MODE :
CLEAR
SAVE : OPEN
BACK : CLOSE
START POSITION SETUP
PRESS MOVE KEY
SAVE : (NEAR)
BACK : (FAR)
STOP POSITION SETUP
PRESS MOVE KEY
SAVE : (NEAR)
BACK : (FAR)