IQinVision Alliance-pro Backbox - Manual (Page 7)

7
b. Attach the other end of the tether to the tether mounting point on the Back Box
using the supplied Phillips head screw.
D. After adjusting camera position, field of view and focus, attach the Dome Bubble/ Trim
Ring assembly to the Back Box by tightening the four (4) Torx screws that are
captively held in the Dome Bubble / Trim Ring assembly.
Alliance-mx
A. Make any cabling connections between the wall side and the IQeye Alliance-mx
camera.
B. Attach the tether from the dome trim ring to the tether mounting point in the
enclosure. Refer to the Alliance-mx Installation and Operating Instructions for
additional details.
C. Rotate the black shroud inside the dome trim ring cover so it aligns with the
camera position.
D. Place the supplied desiccant pack inside the dome to prevent fogging due to
moisture that is present when installing the camera. Use the supplied cable tie to
keep the desiccant from falling down into the dome bubble. Refer to the Alliance-mx
Installation and Operating Instructions for additional details.
E. Attach the dome trim ring cover with shroud to the enclosure by tightening the
three tamper-proof screws with the supplied Torx T-20 security wrench.