INTELLINET NETWORK 524711 Wireless 300N Outdoor PoE Access Point User Manual - Manual (Page 33)

27
Here are descriptions of every setup item:
Select
Click the radio button to select the access
point.
Channel Display to channel number of the access point.
SSID Display the SSID name of the access point.
BSSID Display the BSSID (MAC Address) of the AP.
Encryption Display the encryption setting of the access
points. If you have selected the access point
with a security setting, you need to go to 2-7
Wireless Security to set the same security with
the access point you want to associate with.
Authentication Display the authentication type of the access
point.
Signal The signal strength of each access point will
be displayed here. When the signal strength is
stronger, the connection quality is better.
Mode Display the wireless modes of the access
points: 11b, 11b/g, 11b/g/n or 11n only.
Refresh Click this button to refresh the table.
Connection Select an access point and click to choose the
network. The SSID name of the access point
you have selected will be displayed in the Main
SSID on the Basic Setting page.
2-4-3 AP Bridge-Point to Point Mode
In this mode, this wireless access point will connect to another
wireless access point that uses the same mode, and all wired
Ethernet clients of both wireless access points will be connected
together. You can use this mode to connect a network to another
network that is physically isolated.
NOTE: When you set your access point to this mode, it will not
accept regular wireless clients anymore.
When you select AP Bridge-Point to Point, the following options will
be displayed: