INTELLINET NETWORK 524711 Wireless 300N Outdoor PoE Access Point User Manual - Manual (Page 10)

4
Chapter 2: System and Network Setup
2-1 Connecting the Hardware
Follow these instructions to build the network connection between
the wireless access point and your computer’s network devices:
1. Attach the antennas to the access
point. NOTE: Antenna 1 is the
primary antenna, used while
transmitting/receiving in 11b/g/n
(single antenna) mode.
2. Using the included Ethernet cable,
connect the RJ45 port of the access point to the Power/Data Out
port on the DC injector.
3. Connect the LAN port on the DC injector to your network switch
or hub.
4. Connect the power
adapter to the DC
injector.
5. Using the included
power cord,
connect the power
adapter to an
available AC
outlet. NOTE: Only
use the power
adapter included
with this access
point — not one
from any other
device. (As an
option, however,
see Step 6.)