INSTEON OutletLinc Relay (2473SWH) Manual - Manual (Page 8)

OutletLinc Owner’s Manual
ADVANCED FEATURES
Enabling / Disabling Load Sensing
Load Sensing allows you to manually turn on the load plugged into OutletLinc by using the switch on the
load itself, without sending a command from an INSTEON or X10 controller. When the load is in the off
state (with Load Sensing enabled), OutletLinc will “sense” that you are trying to turn it on with its built-in
switch. When OutletLinc senses this, it will turn on the load automatically.
NOTE: With Load Sensing enabled, some devices have been known to turn on OutletLinc after you have
turned it off. Please use this feature with caution.
By default, Load Sensing is disabled on OutletLinc.
Enable Load Sensing
1) Press & hold the Set button on OutletLinc for 3 seconds
The OutletLinc Status LED will begin blinking
2) Triple-tap the Set button on OutletLinc
The OutletLinc Status LED will stop blinking and turn on solid
3) Test that Load Sensing has been enabled by turning the load on and off from its built-in switch
The load will turn on and off
Disable Load Sensing
1) Press & hold the Set button on OutletLinc for 3 seconds
The OutletLinc Status LED will begin blinking
2) Double-tap the Set button on OutletLinc
The OutletLinc Status LED will stop blinking and turn on solid
3) Test that Load Sensing has been disabled by turning the load on and off from its manual switch
The load will not respond
Page 8 of 14