Hach-Lange TITRALAB Users Guide - Manual (Page 52)

52 Chapter 3
Create an electrode Create an electrode Create an electrode Create an electrode Create an electrode
1. Press 4 Electrode Library, then 1 New electrode.
2. Press
✓ in the Function field and select the function of the
electrode, refer to the table below:
Electrode type Select function
pH single pH
pH combined w/wo temp. sensor pH
Single metal/redox mV (i=0)
Combined metal/redox w/wo temp. sensor mV (i=0)
ISE single ISE or mV (i=0)
ISE combined w/o temp. sensor ISE or mV (i=0)
Conductivity cell w/o temp. sensor Conductivity
Reference single Reference
Temperature sensor T°C
Ground metal Ground
Double metal mV (i > 0)
3. Press
✓ in the ID field.
4. Select Other in the From field.
The option From = Catalogue allows you to create an
electrode from a list of Radiometer Analytical electrodes.
5. Enter the identification (ID
) of the electrode, (up to 16 characters).
6. Press 1 twice.