Hach-Lange BIOGAS User Manual - Manual (Page 9)

9
Installation
3.3 Power connections
Figure 1 Power connection
1. Plug the power cable into the back of the instrument ( Figure 1 ).
2. Insert the plug of the power cable into a grounded mains socket (100–240 V~ / 50–60 Hz).
3. Switch the power button to "On" to turn on the instrument ( Figure 2 , position 13).
N O T I C E
Use only a grounded socket for the connection of this device to the power supply. If you are not sure if the sock-
ets are grounded, have this checked by a qualified electrician. The power plug serves in addition to the power
supply to isolate the device quickly from the power source where necessary. During the disconnection from the
power source it must be made sure that the correct power plug is pulled (for example by labeling the sockets).
This is recommended for long-term storage and can prevent potential dangers in the event of a fault. Therefore
make sure that the socket to which the device is connected is easy to reach by each user at all times.
WA R N I N G
Electrical dangers and fire hazard.
Only use the supplied power cable.
1 Power connection
I
O
1
E1 E1 E2 E2 TEMP TEMP GND GND
5V OUT V OUT
IN IN
T 1A 250V T 1A 250V
TTLTT L
100-240V 100-240Vac ac
50-60Hz 45VA 50-60Hz 45VA
SAC SAC AUX. AUX.
REF REF Pt-Pt Pt-Pt
LINE FUSE T1A L250V LINE FUSE T1A L250V
BALANCE BALANCE
PROPELLER PROPELLER PC/PRINTER PC/PRINTER SLAVE SLAVE
3020116 3020116
Conforms to Conforms to
UL STD 61010A-1
UL STD 61010A-1
Certified to
Certified to
CSA STD C22.2 No. 1010.1
CSA STD C22.2 No. 1010.1
MADE IN FRANCE MADE IN FRANCE RADIOMETER ANALYTICAL SAS RADIOMETER ANALYTICAL SAS
716R999N999 716R999N999