Hach-Lange DR 2800 eco User Manual
Hach-Lange Equipment
This manual is related to the following products:
Table of contents
Document Outline
- DR 2800/DR 2800 eco
- Table of Contents
- Section 1 Specifications
- Section 2 General Information
- Section 3 Installation
- Section 4 Start Up
- Section 5 Standard Operations
- 5.1 Getting Started
- 5.2 Instrument Setup Mode
- 5.3 Storing, Recalling, Sending and Deleting Data
- 5.4 Stored Programs (DR 2800 only)
- 5.4.1 Selecting a saved test/method; entering user-specific basic data
- 5.4.2 Using Program Timers
- 5.4.3 Setting the Dilution Factor
- 5.4.4 Running a Standard Adjust
- 5.4.5 Setting the Chemical Form
- 5.4.6 Running a Reagent Blank
- 5.4.7 Analysis of Samples
- 5.4.8 Updating/Editing LANGE Test
- 5.4.9 Adding Stored Programs to the ”Favorite Programs“ List
- 5.5 Barcode Programs
- 5.5.1 Carrying out a LANGE Barcode Cuvette Test
- 5.5.2 Selecting the measuring range
- 5.5.3 Selecting the chemical evaluation form
- 5.5.4 Basic test-specific and sample-specific data settings
- 5.5.5 Sample blank
- 5.5.6 Updating/Editing LANGE Barcode Cuvette Tests
- 5.5.7 Updating from the Internet
- 5.5.8 Programming your own barcode-readable applications with LCW 906 (DR 2800 only)
- Section 6 Advanced Operations
- 6.1 User Programs (DR 2800 only)
- 6.2 Standard Addition - Monitoring/Checking Results (DR 2800 only)
- 6.3 Single Wavelength (absorbance, concentration and transmittance measurements; DR 2800 only)
- 6.4 Multi-wavelength mode - measurements at more than one wavelength (DR 2800 only)
- 6.5 Time Course of absorbance/transmittance (DR 2800 only)
- 6.6 System Check
- 6.7 Favorite Programs (DR 2800 only)
- Section 7 Maintenance
- Section 8 Troubleshooting
- Section 9 Replacement Parts and Accessories
- Section 10 How To Order
- Section 11 Warranty, liability and complaints
- Appendix A Pour-Thru Cell (DR 2800 only)
- Appendix B Barcode Programs on DR 2800 eco