Section 1 specifications – Hach-Lange SC 1000 Controller Enhanced Communications User Manual
Page 5

5
Section 1
Specifications
Specifications are subject to change without notice.
* USA
The transmitter contained within this product is a ”Tri-Mode” device that can operate in the 850 MHz / 1800 MHz /1900 MHz
bands. The use of this device is not authorized for operation as GSM 1800 Mhz in US & Canadian Territories.
This transmitter is authorized for use in either fixed or mobile locations.
Antennas used with this product must be located such that operation of this device is at least 20 cm (7.9 in) away from all
persons and must not be Co-Located with any other transmitting antenna.
The user is not authorized to use any antenna other than that provided by the manufacturer and shall not exceed 7 dbi for
GSM 1900 and 1.4 dbi for GSM 850 Mhz.
FCC ID:
QIPMC56
IC #:
267W-MC56
CE per Notified Body#: CE 0682
* EUROPE
CAUTION
• Do not operate the device in hospitals and/or near medical instruments such as cardiac pacemakers or hearing aids.
• The device cannot be used in hazardous locations.
• Do not operate the device in the proximity of combustible gases, steams or dust.
• Do not operate the device near highly combustible areas such as gas stations, fuel depots, chemical plants and blasting
works.
• The device can cause disturbances when in the proximity of television sets, radios or PCs.
• Do not expose the device to strong vibrations or impacts.
• Using the GSM services (SMS messages, data communication, GPRS etc.) is likely to incur additional costs from a service
provider. The user is exclusively responsible for any damages and costs incurred.
• Do not use or install this equipment in any manner other than that specified in this manual. Inappropriate use will void the
warranty.
• Any change of the equipment is inadmissible and leads to the loss of the operating permission
• In addition to the safety considerations, obey all the regulations specific to the country in which the device is being operated.
sc1000 controller display module
*GSM/*GPRS modem
The sc1000 display module with integrated GSM/GPRS modem transfers data, SMS
and GPRS services to GSM networks.
The sc1000 controller is available with various GSM frequencies:
Outside the USA: MC55
EGSM900
GSM1800
GSM1900
USA:
MC56
GSM1800
GSM1900
GSM850
MC55/56 supports GPRS multislot class 10 and the GPRS coding schemes CS-1,
CS-2, CS-3 and CS-4.
Modbus TCP server
The Modbus TCP server exhibits "conformance class 0".
This class supports the following function codes:
Read Multiple Registers (FC 3)
Write Multiple Registers (FC 16)
The following function codes are also supported:
Read/Write Multiple Registers (FC 23)
Read Device Information (FC 43/14)
Ethernet port
Ethernet RJ45, 10 MB/s
Warranty
Warranty
2 years