Hach-Lange SC 1000 Controller Enhanced Communications - Manual (Page 13)

13
Installation
3.4.1 Establish a basic Ethernet connection
If the sc1000 controller is located within the corporate network or is used for testing
purposes, a basic Ethernet connection without VPN between the devices is advisable
(
Figure 4 ).
1. Connect the computer to the corporate network using an Ethernet cable. Make sure
the Internet connection is fully functioning. Open various Internet pages to test the
connection.
2. Connect the sc1000 controller to the network by inserting an Ethernet cable into the
RJ45 Ethernet port ( Figure 5 ).
3. Select SYSTEM SETUP>BROWSER ACCESS from the sc1000 controller main
menu to configure network settings.
4. Request the following settings from the IT department if configuring network settings
manually:
• IP ADDRESS
• NETMASK
• DNS IP
• GATEWAY
5. Configure the DHCP setting as follows for automatic configuration:
• DHCP: ON
Figure 4 Basic Ethernet connection
Figure 5 Ethernet port on sc1000 controller display module
1 Ethernet port (used to be service port) on display module
SYSTEM SETUP
BROWSER ACCESS
IP ADDRESS
NETMASK
DNS IP
GATEWAY
DHCP